Preparation before configuration:
1) Power on the camera, press and hold the reset button for a few seconds, and then hear the camera prompt "Reset completed". When the camera prompts "Bluetooth is ready. Please scan the QR code on the camera and wait for connection" and the (starting with BXV) Bluetooth signal is found in the list of the mobile phone, it means that the device is waiting for configuration
2) Turn on Bluetooth and WLAN on the phone and connect the WiFi used to configure the camera network
Configuration steps:
1) Open the APP, click the "+" button in the upper right corner of the device list. Scan the QR code on the device with your mobile phone, and continue to operate according to the system prompts. If the QR code is damaged, click [Can't find the QR code on the device], and select [Bluetooth connection]
2) Select the WiFi to be configured for the device, enter the WiFi password, and click [Confirm]
3) Select the Bluetooth that starts with BXV to connect
4) Camera prompts "Network configuration received - Connecting - Network connected" indicates successful configuration, and APP prompts "Added successfully"
Preparation before configuration:
1) Power on the gateway and plug it into the router, press and hold the reset button on the gateway for a few seconds, wait for all its indicators to go out and then stay on
2) Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts " Reset completed". After the camera kit is started, it will automatically connect to the gateway and prompt "Network connected"
Configuration steps:
1) Open the APP, click the button at the top right corner of the device list, scan the QR code on the gateway with your mobile phone, and continue to operate according to the system prompts. If the QR code is damaged, click [Can't find the QR code on the device], select [Gateway] and follow the system prompts to continue
2) After the system prompts "Bind successfully", click Start Adding Camera to complete the connection
3) If you want to add a non-kit camera, after turning on WLAN on your phone, select the corresponding gateway under the [Gateway] group in the APP device list, click Add Camera, select the gateway network, and follow the system prompts to complete the connection
Gateway indicator light status:
1) Power indicator light( Red )
Off: device powered off
Steady on: system startup completed
Flashing: firmware updating
2) Network indicator light( Green )
Off: not connected to the Internet
Steady on: connected to the Internet
Flashing: poor network connection
3) AP hotspot indicator light( Blue )
Off: AP hotspot disabled
Steady on: AP hotspot enabled
· Power on the camera and observe its status, press and hold the reset button for a few seconds, and then hear the camera prompt "Reset completed". Open the APP, click the "+" button in the upper right corner of the device list to add the device, and continue to operate according to the system prompts. If there is no QR code or the QR code is damaged, click [Can't find the QR code on the device]
· Follow the camera's voice prompts to select the network configuration method, and continue the operation according to the system prompt
1. If the voice prompts "Please scan the QR code on the camera", select [QR code connection]
2. If the voice prompts "Access point ready", select [AP hotspot connection]
3. If the voice prompts "Bluetooth is ready", select [Bluetooth connection]
4. If the voice prompts "WiFi connecting" does not respond, please restore the camera to factory default settings and reconnect according to the above steps
5. If the voice prompts "Network connected" after power on, select [LAN connection] to search for the device and add it
· The device has been successfully connected to the Internet, just add the connected device to the APP
1) Click the "+" button in the upper right corner of the device list, click [Enter manually]
2) Fill in device ID or scan the QR code on device as prompted by the system, then click [Confirm]
3) APP prompts "Added successfully"
